Hot Sale Concrete Foaming Generator CLC Foam Generator

Brief introduction of performance parameters:

TR-30 foam generator is a high-pressure foam preparation machine, which is specially developed for the use of new products developed and tested by scientific research institutions such as universities, scientific research institutes, etc. It is also suitable for small-scale on-site construction projects of decoration companies, such as toilet backfilling and ground cushioning projects. It can also be used for production in small factories.
The operation is simple, fast and durable. The maximum power consumption of this machine is about 3kw, and the maximum bubble making capacity is about 6-8 cubic meters per hour.

Parameters of TR-FG-30 concrete foam generator

Control function: This product is a single-phase 220V/50Hz power supply mode. After the power supply is connected, close the air switch, press the green run button to start running, and press the red stop button to stop the equipment.
Dilute the foaming agent at 1:30, then put the pipette into the diluted liquid, and then follow the control steps to foam normally.
After the equipment is debugged to the best condition, it can be used safely according to the requirements and precautions.

Precautions:
1. There will be air in the pipeline when it is used for the first time, the foaming liquid has not been pumped into the equipment in a short time, and the compressed air pressure has not reached the ideal value. The system will automatically protect it, so you need to wait more than ten seconds for the liquid The foaming operation can be performed normally by filling the entire suction pipe.
2. The air compressor in the foam preparation device should use air compressor oil 100# (summer 150#), the new equipment runs 100 hours to change the oil, and later 300-500 hours to change the oil.
3. Do not start the equipment when the pipeline is blocked to prevent damage to the components due to overpressure in the pipeline.
4. The front end of the bubble tube can be disassembled to replace the steel ball filled in the tube.

Usually need to be disassembled
1. After working for a long time, it is found that the foam shape is not good, generally more than three months of work.
2. Pipe blockage: Some foaming agent remaining in the bubble tube will form a solid residue. In this case, the foam cannot be produced normally, or the pipeline pressure increases sharply. At this time, all the old steel wires need to be taken out, and then replaced with a new one The ball is fine. Steel wire ball specification requirements: each blowing tube needs to be filled with about 10 steel wire balls. Too much or too little will affect or even destroy the foam performance.

Safety reminder
Remember to use electricity safely. If water or foam touches the circuit, you must immediately cut off the power at the remote end to ensure safe production.